Fabbricazione di monitor a telaio aperto da 19 pollici

the client show me drawing ;looks design as well ;

19 inch open frame drawing

the hole mark A , B , C one by one , and the material ,surface tech demand list clear;

but when i open it to fabrication , fond the some hole too close the bend edge ; almost stuck the tool ;

the monitor frame bend stuck with the hole

so, the client kindly discuss and advise the hole move up more 1.2mm ,

i am not sure it's can solved it , try to make it first ;

the back design looks good , the interface IO plate can be replace when the motherboard changed

the flat bend drawing spent my 2 hours ; it's terrible ; because the bend edge many cut to different sharp, so, NX cant' recognize it ,

finally, the extend drawing as below ;

·